LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Wiring Systems (General Information)) >> Repair Instructions >> Underhood Electrical Center or Junction Block Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Engine Electrical.
  2. Remove the left fender upper brace.
    Fig 1: Removing Left Fender Upper Brace
    G01457233Courtesy of GENERAL MOTORS CORP.
  3. Remove the electrical center brace cover assemble by lifting the cover (3) outwards to clear the tabs.
  4. Remove all fuses and relays.
    Fig 2: Removing Electrical Center Brace Cover Assemble
    G01457234Courtesy of GENERAL MOTORS CORP.
  5. Push on the tab (3) so that the electrical center can be rotated on the studs located at (2).
  6. Remove all connectors by removing the bolt (1) for each connector.
  7. Disconnect all connectors from the electrical center block.
    Fig 3: Disconnecting Connectors From Electrical Center Block
    G01457235Courtesy of GENERAL MOTORS CORP.
  8. Push on the tabs (2) in order to lift the electrical center (1) out of the housing.
    Fig 4: Lifting Electrical Center Out Of Housing
    G01457236Courtesy of GENERAL MOTORS CORP.
  9. To replace the engine electrical center bracket remove the 4 retaining bolts (1).
  10. Remove the engine electrical center bracket assembly from the fender.
    Fig 5: Removing Engine Electrical Center Bracket Assembly From Fender
    G01457237Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals