LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Push to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Fig 1: Removing TPA Device, CPA Device & Secondary Lock
G01457223Courtesy of GENERAL MOTORS CORP.
  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
    Fig 2: Separating Connector Halves & Gently Pull Cable & Terminal Out Of Back Of Connector
    G01457224Courtesy of GENERAL MOTORS CORP.
  3. Use the proper pick or removal tool (1) in order to release the terminal.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
    Fig 3: Re-Forming Locking Device
    G01457225Courtesy of GENERAL MOTORS CORP.
  5. Re-form the locking device if you are going to reuse the terminal (1).
  6. To repair the terminal, refer to Terminal Repair.
scientia non olet · About LEMON Manuals