LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1490 (Rear Wheel Steering System) >> Diagnostic Information and Procedures >> DTC C0522: Position "A" Or "B" Signal Circuit On Rear Position Sensor Out-Of-Range >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. This step requires the technician to perform the diagnostic procedure for the control module.
  2. The minimum high limit is the value of voltage above which the code will set. The maximum low limit is the value of voltage below which the code will set.
  3. Test for the proper operation of the position 1 or position 2 circuit in the high voltage range. Use a connector test adaptor kit in order to jumper the connections between the rear position sensor and the harness connector.
  4. Test for the proper operation of the position 1 or position 2 circuit in the high voltage range.
  5. Test for short to ground in the 5 volt reference circuit.
    Fig 1: DTC C0522 (Step 1-7)
    G01455283Courtesy of GENERAL MOTORS CORP.
    Fig 2: DTC C0522 (Step 8-15)
    G01455284Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals