Removal & Installation (Impala)
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Remove Instrument Panel Cluster (IPC) trim plate. Remove left and right A-pillar mouldings. Starting from right side, carefully lift upwards on defroster grille to release retainers. Disconnect Daytime Running Light (DRL) sensor from defroster grille.
- Remove defroster grille. Remove upper trim pad screws. Remove remote keyless entry module. Remove instrument panel trim pad.
- To install, reverse removal procedure. Tighten trim pad screws to specification. See TORQUE SPECIFICATIONS . Activate air bag system.