LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Monte Carlo-Driver-side)

Removal & Installation (Monte Carlo-Driver-side)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Tilt steering wheel to lowest position. Turn steering wheel until one of 3 holes located on back side of steering wheel is straight above steering column. Insert a small, flat bladed screwdriver into hole and twist to remove spring loaded fastener. Repeat procedure for remaining spring loaded fasteners. Pull driver-side air bag module away from steering wheel.
  3. Remove Connector Position Assurance (CPA) clips and remove air bag module connectors. See Figure. Push and rotate horn contact lead 1/4 turn clockwise and remove. Remove air bag module.
  4. To install, reverse removal procedure. Ensure wires are not pinched during assembly. Activate air bag system.
scientia non olet · About LEMON Manuals