Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transmission Cooler Liners To The Vehicle

Courtesy of GENERAL MOTORS CORP.

Clip the transaxle oil cooler to the radiator.
Clip the condenser to the radiator.

Fig 2: View Of CRFM Mounting Brackets To The Radiator Support

Courtesy of GENERAL MOTORS CORP.

Install the upper CRFM bracket assemblies.

Fig 3: View Of CRFM Closeout/Splash Panel To Condenser

Courtesy of GENERAL MOTORS CORP.

Install the condenser splash shield.

Fig 4: Battery Box Air Duct

Courtesy of GENERAL MOTORS CORP.

Install the battery box inlet air duct.
Install the oil cooler line-to-radiator bracket bolt.

Fig 5: View Of Transaxle Oil Cooler Lines

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the transaxle oil cooler lines to the radiator.
Tighten: Tighten the transaxle cooler line fittings to 16 N.m (12 lb ft).
Install the fascia. Refer to Fascia Replacement - Front Bumper installation procedure in Body and Accessories.