LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Oil Cooler Line Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transaxle oil cooler line assembly to the transaxle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the transaxle oil cooler line assembly nut.

    Tighten:  Tighten the transaxle oil cooler lines to 7 N.m (62 lb in).

  3. Lower the vehicle.
  4. Connect the transaxle oil cooler lines to the radiator.

    Tighten:  Tighten the transaxle cooler line fittings to 16 N.m (12 ft lb).

    5. NOTE: Saturn automatic transaxle fluid (ATF), P/N 21005966 and P/N 21019223, is not compatible with this transaxle. If Saturn ATF is used, transaxle damage will result. This transaxle uses Saturn T-IV fluid P/N 22689186.
  5. Add fluid to the transaxle. Refer to the Transmission Fluid Checking Procedure located in this manual.
  6. Start the engine a check for leaks.
scientia non olet · About LEMON Manuals