LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Manual Shift Detent Lever and Park Pawl Installation

Manual Shift Detent Lever and Park Pawl Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Pawl Pin Spring, Guide Sleeve & Bolt/Screw
    GM749462Courtesy of GENERAL MOTORS CORP.
  1. Install the park pawl pin spring (704).
  2. Install the park pawl pin spring guide sleeve (705).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the park pawl bolt/screw (706).

    Tighten:  Tighten the park pawl bolt/screw to 7.8-11.8 N.m (69.0-104.40 lb in).

    4. Fig 2: View Of Park Pawl Spring Pin
    GM749461Courtesy of GENERAL MOTORS CORP.
  4. Install the park pawl spring pin (703).
    5. Fig 3: View Of Park Pawl & Actuator Bracket
    GM798649Courtesy of GENERAL MOTORS CORP.
  5. Install the park pawl (702) and the park pawl actuator bracket (708).
    6. Fig 4: View Of Park Pawl Shaft & Return Spring
    GM798650Courtesy of GENERAL MOTORS CORP.
  6. Install the park pawl return spring (701).
  7. Install the park pawl shaft (700).
    8. Fig 5: View Of Manual Shift Detent Spring Assembly
    GM749456Courtesy of GENERAL MOTORS CORP.
  8. Install the manual shift detent spring assembly (711).
    9. Fig 6: View Of Manual Shift Detent Lever Spring Bolt/Screw & Park Pawl Actuator Bracket Bolt/Screw
    GM749455Courtesy of GENERAL MOTORS CORP.
  9. Install and hand tighten the 14 mm manual shift detent lever spring bolt/screw (712) and the 16.7 mm park pawl actuator bracket bolt/screw (715).

    Tighten: 

    • Tighten the 14 mm manual shift detent lever spring bolt/screw (712) to 3.9-6.9 N.m (34.5-61.0 lb in).
    • Tighten the 16.7 mm park pawl actuator bracket bolt/screw (715) to 7.8-11.8 N.m (69.0-104.40 lb in).

    10. Fig 7: View Of Park Pawl Actuator Rod
    GM749454Courtesy of GENERAL MOTORS CORP.
  10. Install the park pawl actuator rod (709).
    11. Fig 8: View Of Manual Shift Detent Lever Assembly
    GM749453Courtesy of GENERAL MOTORS CORP.
  11. Install the manual shift detent lever assembly (710).
    12. IMPORTANT: The park pawl actuator rod (709) must be installed with the rod between the case and the manual shift detent lever.
  12. Connect the park pawl actuator rod (709) to the manual shift detent lever assembly (710).
    13. Fig 9: Lifting Manual Shift Detent Lever Spring
    GM874467Courtesy of GENERAL MOTORS CORP.
  13. Using a screwdriver, lift the manual shift detent lever spring (711) and rotate the manual shift detent lever assembly (710) into position.
scientia non olet · About LEMON Manuals