LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1459 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> 1-2 Reverse Carrier Gear Assembly Installation

1-2 Reverse Carrier Gear Assembly Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of 1-2 Reverse Internal Gear, Front Thrust Bearing Assembly & Rear Thrust Bearing Assembly
    GM749472Courtesy of GENERAL MOTORS CORP.
  1. Rotate the transmission case assembly so that the torque converter housing side is facing up.
  2. Install the 1-2 reverse internal gear rear thrust bearing assembly (595) with the flat side up.
    3. IMPORTANT: A shim (596) is available for proper endplay for the front differential transfer drive gear assembly. Early production transmission did not use the shim.
  3. Install the 1-2 reverse internal gear shim (596) without any markings. Correct shim selection is performed during the front differential transfer drive gear assembly installation.
  4. Install the 1-2 reverse internal gear front thrust bearing assembly (593) with the flange up.
    5. Fig 2: View Of 1-2 Reverse Carrier Gear Assembly
    GM749470Courtesy of GENERAL MOTORS CORP.
  5. Install the 1-2 reverse internal gear thrust washer (590) to the lower side of the 1-2 reverse carrier gear assembly (591).
  6. Install the 1-2 reverse carrier gear assembly (591) into the 1-2 reverse internal gear (594). The carrier assembly will be flush to the 1-2 reverse internal gear.
  7. Install the 1-2 reverse carrier thrust washer (590) on top of the 1-2 reverse carrier gear assembly (591).
scientia non olet · About LEMON Manuals