LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1458 (Roof) >> Diagnostic Information and Procedures >> Power Sunroof Does Not Open to Express Position >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  If the express open feature does operate properly, then suspect the express open signal circuit for a poor connection or intermittent.
Power Sunroof Does Not Open to Express Position

Step Action Value(s) Yes No
Schematic Reference: Power Sunroof Schematics 
Connector End View Reference: Power Roof Systems Connector End Views 
DEFINITION: Express open feature is inoperative.
1 Did you perform the Power Sunroof Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Power Sunroof 
2  Operate the power sunroof express open feature.
Does the system operate normally?		 - Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Remove the sunroof switch from the headliner.
  2. Turn the ignition ON, with the engine OFF.
  3. Operate the sunroof switch to slide the sunroof glass to the close position.
  4. Connect a jumper wire between the sunroof switch express signal circuit and the sunroof switch open signal circuit at the sunroof switch harness connector.
  5. Press the sunroof switch to the express open position.
Does the sunroof glass express open?		 - Go to Step 7  Go to Step 4 
4
  1. Disconnect the sunroof switch from the harness connector.
  2. Measure the reference voltage of the sunroof switch express signal circuit of the sunroof switch harness connector to a known good ground.
Does the voltage measure near the specified value?		 B+ Go to Step 9  Go to Step 5 
5 Test the sunroof switch express signal circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 6 
6 Inspect the sunroof switch express signal circuit for a poor connection at the sunroof module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 9 
7 Inspect for a poor connection at the sunroof switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 8 
8 Replace the sunroof switch. Refer to Sunroof Switch Replacement .
Did you complete the replacement?		 - Go to Step 10  -
9 Replace the sunroof module. Refer to Sunroof Control Module Replacement .
Did you complete the replacement?		 - Go to Step 10  -
10
  1. Turn OFF the ignition.
  2. Remove any jumper wires.
  3. Reconnect all previously disconnected components.
  4. Operate the system in order to verify the repair.
Did you correct the condition?		 - System OK Go to Step 3 
scientia non olet · About LEMON Manuals