LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1457 (Seat Belts) >> Repair Instructions >> Seat Belt Buckle Replacement - Front (Quick Connect) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shoulder Belt Quick Disconnect Bolt
    GM987242Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Install the shoulder belt quick disconnect.

    Tighten:  Tighten the fasteners to 50 N.m (37 lb ft).

    2. Fig 2: Side Trim & Fasteners
    GM981027Courtesy of GENERAL MOTORS CORP.
  2. Install the side trim with the fasteners.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    3. Fig 3: View Of Front Seat Back Recliner Trim Panel
    GM981031Courtesy of GENERAL MOTORS CORP.
  3. On the passenger side, install the recliner side cover with the fasteners.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    4. Fig 4: Recliner Handle Trim
    GM981017Courtesy of GENERAL MOTORS CORP.
  4. On the driver side, install the recliner and seat riser covers by firmly pushing on the handle cover.
  5. Install the front seat to the vehicle. Refer to Seat Replacement - Front Bucket in Seats.
    6. IMPORTANT: Verify that the shoulder belt is not twisted.
  6. Install the shoulder belt into the shoulder belt quick disconnect.
scientia non olet · About LEMON Manuals