Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the front tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

Fig 1: Identifying Tie Rod Inner Jam Nut

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Mark the location of the jam nut for installation.

Loosen the tie rod inner jam nut.

Fig 2: View Of Tie Rod End To Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Hold the ball stud to prevent turning during removal of the nut.

Remove the tie rod to knuckle nut. Discard the nut.

Fig 3: Separating Outer Tie Rod End From Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.

Use the SA91100C to separate the tie rod from the steering knuckle.

Fig 4: View Of Outer & Inner Tie Rods

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod from the inner tie rod.