Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC will clear on the next malfunction free ignition cycle.
- A history DTC will clear after 100 consecutive malfunction free ignition cycles.
- Using a scan tool
DTC C0475
| Step | Action | Yes | No |
|---|---|---|---|
| Connector End Views Reference: Power Steering System Connector End Views | |||
| 1 | Did you perform the Power Steering Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Power Steering System |
| 2 | Inspect for poor connections at the EPS motor harness connector, refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 3 |
| 3 | Test the EPS motor control circuits for a short to ground or an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Test the EPS motor control circuits for a short to voltage. Refer to Testing for a Short to Voltage
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the EPS assembly. Refer to Steering Column Replacement
in Steering Wheel and Column. Did you complete the repair? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | System OK |