LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1452 (Seats) >> Repair Instructions >> Seat Back Recliner Handle Replacement - Front (Non-Fold Flat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Recliner Handle Bolt & Spring
    GM986806Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Position the recliner handle to the adjuster with the fastener and the spring. Secure the handle in place with the recliner handle bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Installing Screw To Outer Trim Panel
    GM981027Courtesy of GENERAL MOTORS CORP.
  2. Position the outer trim panel to the seat cushion. Secure the trim panel with the screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    3. Fig 3: Recliner Handle Trim
    GM981017Courtesy of GENERAL MOTORS CORP.
  3. Install the recliner handle trim.
    4. Fig 4: Seat Riser Handle Trim
    GM981011Courtesy of GENERAL MOTORS CORP.
  4. Install the seat riser handle trim.
  5. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals