LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1444 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2627: Instrument Panel Dimming Lamps Output Is Open Or Shorted To Ground >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

If the DTC is a history DTC, the malfunction may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

DTC B2627

Step Action Yes No
Schematic Reference: Interior Lights Dimming Schematics 
1 Did you perform the Lighting System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2
  1. Turn the ignition switch to the on position.
  2. Turn the headlamp switch to the on position.
  3. Attempt to adjust the lighting intensity of the instrument lamps with the dimmer switch.
Do the instrument panel lamps vary with dimmer control?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Is DTC B2622 or B2623 set? Go to DTC B2622  or DTC B2623  Go to Step 4 
4 Test for an open, high resistance, or short to ground on the instrument panel lamps supply voltage circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 7  Go to Step 5 
5 Inspect for poor connections at the harness connector of the body control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 7  Go to Step 6 
6
IMPORTANT: Perform the set up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.
Replace the body control module. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 7  -
7
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals