LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1441 (Instrument Panel, Gages, And Console) >> Diagnostic Information and Procedures >> Chime Always On

Chime Always On

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Chime Always On

Step Action Yes No
Schematic Reference: Audible Warnings Schematics 
1 Did you perform the Audible Warnings Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Audible Warnings 
2 Are any indicators illuminated? Go to Symptoms - Instrument Panel, Gages and Console  Go to Step 3 
3
  1. Turn the ignition OFF.
  2. Turn the headlamp switch to OFF.
  3. Remove the key from the ignition.
  4. Open the driver door.
Does the chime sound?		 Go to Step 4  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
4
  1. Turn the ignition OFF.
  2. Disconnect the ignition switch.
  3. Install a scan tool.
  4. Turn the ignition ON, with the engine OFF.
  5. With a scan tool, observe the Key in Ignition parameter in the Body Control Module Switch Inputs data list.
Does the Key in Ignition parameter display No?		 Go to Step 6  Go to Step 5 
5 Test the key in ignition signal circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 8  Go to Step 7 
6 Replace the ignition switch. Refer to Ignition Switch Replacement in Steering Wheel and Column.
Did you complete the replacement?		 Go to Step 8  -
7
IMPORTANT: Program the replacement BCM.
Replace the BCM. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals