LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Side Impact AIR Bag)

Removal & Installation (Side Impact AIR Bag)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove applicable front seat from vehicle. Remove seat back cover. Remove side impact air bag module mounting bolts. See Fig 1. Remove air bag module retainer. Remove wire harness clips from seat frame. Make note of wire harness positioning in seat frame for use during installation. Remove wire harness from seat frame. Remove side impact air bag module.
  3. To install, reverse removal procedure. Ensure that wire harness is installed in same position as it was removed from to prevent damage to wires. Tighten side impact air bag module mounting bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system.
Fig 1: Identifying Side Impact Air Bag Module
G99E26231Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals