Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat belt retractor into the T-slot in the center pillar.
NOTE: Refer to FASTENER NOTICE .
Install the seat belt retractor side belt bolt.
Tighten

Tighten the seat belt retractor bolt to 68 N.m (50 lb ft).

Fig 1: Installing Anchor Plate Nut To Seat Stud
Courtesy of GENERAL MOTORS CORP.
Install the intermediate guide bolts.
Tighten

Tighten the intermediate guide bolts to 10 N.m (89 lb in).

Fig 2: Installing Intermediate Guide Bolts
Courtesy of GENERAL MOTORS CORP.
Position the anchor plate to the seat stud.

Fig 3: Installing Anchor Plate Nut
Courtesy of GENERAL MOTORS CORP.
Install the anchor plate nut to the seat stud.
Tighten

Tighten the anchor plate nut to 42 N.m (31 lb ft).
Install the quarter panel trim. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER LOWER (SEDAN) .
Position the seat belt guide loop to the guide adjuster bracket.
Install the guide loop nut.
Tighten

Tighten the seat belt guide loop nut to 42 N.m (31 lb ft).
Close the seat belt guide loop cover.

Fig 4: Seat Belt Guide Loop
Courtesy of GENERAL MOTORS CORP.