Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wire connector (6).
- Secure the wire harness along the out board flange (7) and (2).
- Secure clip (1) and clip (3) to sunroof module flange.
- Loop the wire harness around cable drive (4).
- Connect the wire harness (5) to the sunroof motor.
- Install the headliner. Refer to HEADLINER REPLACEMENT .
- Inspect the operation of the sunroof.
IMPORTANT:
Do not route the wire harness on the top or the bottom of the flange as it will get pinched during sunroof operation.