Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Position the floor console to the vehicle.
Connect the electrical connectors to the floor console.

Fig 1: Connecting Electrical Connectors To Floor Console
Courtesy of GENERAL MOTORS CORP.
Align the floor console over the transaxle shifter and position the floor console retainers to the IP.
Push the floor console forward into the retainers in the IP until fully seated.

Fig 2: Pushing Floor Console Forward Into Retainers In IP
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the floor console horizontal bolts near the IP.
Tighten

Tighten the floor console horizontal bolts to 5 N.m (44 lb in).

Fig 3: Installing Floor Console Horizontal Bolts Near IP
Courtesy of GENERAL MOTORS CORP.
Install the floor console bracket bolts at the rear of the transaxle shifter lever.
Tighten

Tighten the floor console bracket bolts to 5 N.m (44 lb in).
Install the floor console rear compartment bolts.
Tighten

Tighten the floor console rear compartment bolts to 5 N.m (44 lb in).

Fig 4: Installing Floor Console Rear Compartment Bolts
Courtesy of GENERAL MOTORS CORP.
Install the floor console rear compartment mat.

Fig 5: Installing Floor Console Rear Compartment Mat
Courtesy of GENERAL MOTORS CORP.
Install the floor console trim plate. Refer to TRIM PLATE REPLACEMENT - CONSOLE FRONT .
Install the floor console power accessory port. Refer to POWER ACCESSORY PORT REPLACE - FRONT FLOOR CONSOLE .
Install the floor console lighter. Refer to CIGAR LIGHTER REPLACEMENT - CONSOLE .
Reposition the transaxle shift lever to the PARK position.
Release the parking brake.