LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Fuel Injector Sight Shield Replacement (L36) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tube/oil fill cap from the valve rocker arm cover.
  2. Insert the tab of the fuel injector sight shield under the engine bracket.
    Fig 1: Installing Tube/Oil Fill Cap & Fuel Injector Sight Shield (L36)
    G01968302Courtesy of GENERAL MOTORS CORP.
  3. Place the hole of the fuel injector sight shield onto the oil fill neck of the valve rocker arm cover.
  4. Install the tube/oil fill cap into the valve rocker arm cover and twist clockwise in order to lock the detent on the tube into the notch in the cover.
scientia non olet · About LEMON Manuals