LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Controls - System & Component Testing) >> Emission Systems & Sub-Systems (Gasoline) >> Evaporative Emission System Cleaning >> Cleaning Procedure

Cleaning Procedure

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2002 Saturn Vue, 2002 Pontiac Montana, 2002 Pontiac Aztek, 2002 Oldsmobile Silhouette, and 2002 Oldsmobile Bravada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove EVAP canister.
  2. Turn OFF main valve on EVAP Pressure/Purge Diagnostic Station (J 41413).
  3. Disconnect hose from diagnostic station pressure regulator.
  4. Using a section of vacuum hose, connect one end onto diagnostic station pressure regulator.
  5. Connect other end of vacuum hose to canister side of purge pipe.
  6. Turn ON main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
  7. If nitrogen does not dislodge carbon particles, replace purge pipe.
  8. Return EVAP pressure/purge diagnostic station to original condition of station.
  9. Install a new EVAP canister.
  10. Connect all previously disconnected EVAP pipe connectors.
  11. Lower vehicle.
  12. Return to appropriate DTC service procedure.
scientia non olet · About LEMON Manuals