Diagnostic Procedure
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2002 Saturn Vue, 2002 Pontiac Montana, 2002 Pontiac Aztek, 2002 Oldsmobile Silhouette, and 2002 Oldsmobile Bravada. However, it is still accessible from the selected car via links, so may be relevant.
- Operate engine until it reaches normal operating temperature.
- Disconnect engine vacuum harness from vacuum pump inlet pipe.
- Connect Valve Manometer (J 23951), or vacuum gauge, to vacuum pump inlet pipe.
- Operate engine at an idle for 30 seconds. If engine operates for longer than 30 seconds, or if engine does not operate at an idle, vent manometer and repeat this step.
- While operating engine, observe manometer reading. Reading should be within specification. See VACUUM PUMP SPECIFICATIONS table.VACUUM PUMP SPECIFICATIONS
Elevation - Ft. Minimum Specification - In. H2 O (kPa) Zero 21 (-70) 5000 18 (-60) 10,000 14 (-49) 15,000 12 (-40) - If vacuum pump fails to meet minimum specifications, replace vacuum pump and retest