LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tilt head onto the steering shaft.
  2. Install the tilt head housing and steering shaft as an assembly. Refer to STEERING SHAFT, LOWER BEARING, AND JACKET REPLACEMENT (COLUMN SHIFT)  or STEERING SHAFT, LOWER BEARING, AND JACKET REPLACEMENT (FLOOR SHIFT)  .
    IMPORTANT: The switch mounting bracket must be pressed firmly against the steering column tilt head.
  3. Slide the turn signal switch housing onto the steering column shaft assembly.
  4. Install the turn signal and multifunction switch assembly only. Refer to MULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENT  .
  5. Install the turn signal cancel cam assembly. Refer to TURN SIGNAL CANCEL CAM AND UPPER BEARING THRUST WASHER  .
  6. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in Air Bag Restraint Systems.
    Fig 1: Installing Tilt Head Onto Steering Shaft
    G01569304Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals