LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Steering Wheel And Steering Column) >> Repair Instructions >> Seal Replacement - Intermediate Steering Shaft >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate shaft lower seal over the intermediate shaft and to the steering gear.
  2. Install the intermediate shaft upper seal over the lower seal and to the instrument panel.
  3. Connect the intermediate shaft to the steering column. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT  .
  4. Install the intermediate shaft seal to the steering column.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the intermediate shaft seal bolts.

    Tighten 

    Tighten the intermediate shaft seal bolts to 3 N.m (27 lb in).

    Fig 1: Installing Intermediate Shaft Seal & Mounting Bolts
    G01569223Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals