Removal & Installation (Van)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 GMC C3500 HD, and 2002 Chevrolet RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove the fuel tank filler cap. Remove the protective cover from fuel manager/filter. Open the air bleed valve on top of the fuel manager/filter in order to release any of the pressure in the fuel supply system. Disconnect the fuel heater connector. Remove the fuel heater threaded nut by turning counterclockwise. Use a hand pressure or a strap wrench in order to remove the fuel heater threaded nut. Remove the fuel heater from the filter housing by pulling straight up.
- Install the cap seal into the filter housing. Install the fuel heater by pushing straight down. Install the fuel heater threaded nut. Reconnect fuel heater connector. Install the protective cover on the fuel manager/filter. Install the fuel tank filler cap. Bleed the air from the fuel manager/filter. See FUEL FEED & FUEL RETURN PIPE PURGE . Lower the vehicle.