Removal & Installation (Metal Collar)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the "O" rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
- Disconnect negative battery cables. Remove the fuel filler cap. Remove the retainer from the quick-connect fitting. Blow dirt out of the fitting using compressed air. Choose the correct end from Fuel Line Disconnect Tool (J 44581) the for the size of the fitting. Insert the tool into the female connector, then push inward in order to release the locking tabs. Pull the connection apart.
- If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the "O" ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.
- Apply a few drops of clean engine oil to the male pipe end. Push both sides of the fitting together in order to snap the retaining tabs into place. Once installed, pull on both sides of the fitting to ensure the connection is secure.