LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Fuel Systems >> Fuel Sender Assembly >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Relieve the fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Drain the fuel tank. Remove the fuel tank. See FUEL TANK .
  2. Remove the retaining ring from the fuel sender assembly using Fuel Sender Lock Nut Wrench (J 39765). Remove the fuel sender assembly and the seal. Discard the seal. Clean the fuel sender sealing surfaces. Install the NEW seal on the fuel tank.
    3. NOTE: The fuel strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender assembly, assure that the fuel strainer does not block full travel of the float arm.
  3. Install the fuel sender assembly into the fuel tank. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals