LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1363 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement-Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left side end panel.
  2. Remove the knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  3. Disconnect all the wiring connectors from the fuse block.
  4. Remove all the fuses.
  5. Remove the turn signal relay from the back of the fuse block.
  6. From behind the fuse block, remove the retaining bolt.
  7. Insert a screw driver between the fuse block and the wire harness block to separate.
  8. Push on the retainers in order to remove the fuse block.
  9. Remove the fuse block from the vehicle.
Fig 1: Left Instrument Panel Electrical Center Or Junction Block
G01576963Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals