Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the clutch pedal position switch electrical connector (1).
Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.

Fig 1: Disconnecting Clutch Pedal Position Switch Electrical Connector
Courtesy of GENERAL MOTORS CORP.
If equipped with a NV 3500 or NV 4500 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
Remove the clutch master cylinder clip from the brake pressure module valve pipe.

Fig 2: Disconnecting Clutch Actuator Cylinder
Courtesy of GENERAL MOTORS CORP.
If equipped with a ZF S6-650 transmission, disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.

Fig 3: Disconnecting Clutch Actuator Cylinder To Clutch Master Cylinder
Courtesy of GENERAL MOTORS CORP.
Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position.

Fig 4: Rotating Clutch Master Cylinder
Courtesy of GENERAL MOTORS CORP.
If equipped with a NV 3500 or NV 4500 transmission, remove the clutch master cylinder.

Fig 5: Removing Clutch Master Cylinder (NV 3500 Or NV 4500)
Courtesy of GENERAL MOTORS CORP.
If equipped with a ZF S6-650 transmission, remove the clutch master cylinder.

Fig 6: Removing Clutch Master Cylinder (ZF S6-650)
Courtesy of GENERAL MOTORS CORP.