LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1361 (Automatic Transmission - 4L80-E - Service & Replacement) >> Diagnostic Information and Procedures >> Shift Solenoid Leak Test >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

J 44246  Solenoid Testing Kit

IMPORTANT:
  • This procedure tests On/Off type solenoid valves.
  • Visually inspect the physical condition of the solenoid before testing. Inspect the O-ring before and after the test to be sure that they are not cut or damaged.
  1. Remove the solenoid from the control valve body.

    Refer to Valve Body And Pressure Switch Replacement   . 

    Fig 1: Installing Shift Solenoid Valve Into J 44246 Bore
    G01952235Courtesy of GENERAL MOTORS CORP.
  2. Install the 1-2 shift solenoid valve or the 2-3 shift solenoid valve into bore number 1 of the J 44246  and install the factory bolt to retain the solenoid.
    Fig 2: Connecting Solenoid Testing Harness
    G01952236Courtesy of GENERAL MOTORS CORP.
  3. Connect the solenoid testing harness supplied with the J 44246  to the solenoid.
    IMPORTANT: Do not use air pressure in excess of 120 psi. Excessive pressure will not allow the solenoid ball check valve to seat properly. Recommended air pressure is 50 psi.
  4. Apply compressed air to the J 44246. 
  5. Air should flow through the solenoid. If air does not flow through the solenoid, replace the solenoid. Refer to Valve Body And Pressure Switch Replacement   . 
  6. Connect the solenoid testing harness to the 12 volt positive and negative (-) battery terminals.
  7. Observe if the solenoid is operating electrically. An audible clicking noise can be heard when connecting or disconnecting power.
    IMPORTANT:
    • All solenoids need to be energized to seal.
    • A small amount of air leakage is normal +/-21 kPa (+/-3 psi).
  8. Observe the air flow through the solenoid. The flow will completely or nearly completely stop. Replace the solenoid if there continues to be an obvious air leak when the solenoid is energized.
    IMPORTANT: Inspect the O-rings after the test to be sure that they are not cut or damaged.
  9. Install the solenoid into the control valve body. Refer to Valve Body And Pressure Switch Replacement   . 
scientia non olet · About LEMON Manuals