LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1360 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the O-ring seal (3) onto the VSS (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the VSS (1).
    NOTE: Refer to FASTENER NOTICE .
  4. Install the VSS bolt (2).

    Tighten 

    Tighten the bolt to 11 N.m (97 lb in).

    Fig 1: Installing O-Ring Seal, Vehicle Speed Sensor & Bolt
    G01953665Courtesy of GENERAL MOTORS CORP.
  5. Connect the VSS electrical connector (2).
  6. Lower the vehicle.
  7. Refill the fluid as required.
    Fig 2: Connecting Vehicle Speed Sensor Electrical Connector
    G01953666Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals