LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1360 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Repair Instructions >> Manual Shift Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the park/neutral position (PNP) switch. Refer to Park/Neutral Position Switch Replacement   . 
  2. Ensure that the jackscrew for J 43911  is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal.
    Fig 1: Steel Shell & Selector Shaft
    G01953592Courtesy of GENERAL MOTORS CORP.
  3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to ensure that the removal tool is firmly attached to the seal shell.
  4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
scientia non olet · About LEMON Manuals