LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1359 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Transmission Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The J 44732  will set the oil seal to the proper depth. Failure to use the J 44732  will cause improper installation of the oil seal.
  1. Using J 44732  install the rear oil seal.
    Fig 1: Installing Rear Oil Seal
    G01953189Courtesy of GENERAL MOTORS CORP.
  2. Install the yoke.
  3. Use the J 8614-01  in order to hold the yoke.
    NOTE: Refer to FASTENER NOTICE .
  4. Install a NEW yoke nut.

    Tighten 

    Tighten the nut to 330 N.m (244 lb ft).

  5. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE or PROPELLER SHAFT REPLACEMENT - TWO PIECE .
  6. Check the transmission fluid level. Add if necessary.
  7. Lower the vehicle.
    Fig 2: Installing Yoke & Nut
    G01953190Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals