LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Battery) >> Repair Instructions >> Battery Positive Cable Replacement - Auxiliary (6.6L Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Loosen the auxiliary battery positive cable bolt.
  3. Remove the auxiliary battery cable clip from the wheelhouse inner panel.
  4. Remove the auxiliary battery cable clip from the frame.
  5. Raise and suitably support the vehicle. Refer to JACKING AND LIFTING .
    Fig 1: Remove Auxiliary Battery Cable Clips
    G02109421Courtesy of GENERAL MOTORS CORP.
  6. Remove the starter lead nut.
  7. Remove the auxiliary positive battery cable from the starter solenoid stud.
    Fig 2: Remove Starter Lead Nut & Battery Cable
    G02109422Courtesy of GENERAL MOTORS CORP.
  8. Remove the auxiliary battery negative cable bolt.
    Fig 3: Remove Auxiliary Battery Negative Cable Bolt
    G02109423Courtesy of GENERAL MOTORS CORP.
  9. Remove the battery cable retainer nut.
  10. Remove the auxiliary positive cable from the retainer.
  11. Remove the auxiliary battery cable.
    Fig 4: Remove Battery Cable Retainer Nut
    G02109424Courtesy of GENERAL MOTORS CORP.