LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1354 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the O-ring seal for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be reused.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal onto the oil level indicator tube.
  4. Install the oil level indicator tube into the engine block and rotate into proper position.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the tube bolt.

    Tighten 

    Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

  6. Install the oil level indicator into the tube.
    Fig 1: Install Oil Level Indicator, Tube & Bolt
    G02107288Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals