LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine Controls Removal & Installation) >> Ignition Systems >> Ignition Coil >> Removal & Installation (2.2L - VIN F)

Removal & Installation (2.2L - VIN F)

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. The ignition coils are located in a housing in the camshaft cover. See Fig 1. Turn ignition off. Disconnect negative battery cable. Remove the accelerator cable from the bracket. Remove the accelerator cable bracket bolt. Remove the accelerator cable bracket. Disconnect the Ignition Control Module (ICM) harness connector. Remove the ICM retaining screws. Remove the ICM from the ignition coil housing.
  2. Remove the ignition coil housing retaining bolts. Remove the ignition coil housing from the camshaft cover. To install, reverse removal procedure. tighten bolts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Removing Ignition Coil Housing (2.2L - VIN F)
G00129176Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals