LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Replacement (9.75 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the axle shaft.
    2. Fig 1: Installing Axle Shaft
    G01480631Courtesy of GENERAL MOTORS CORP.
  2. Install the spring loaded lock clip to the axle shaft end.
  3. Install the steering knuckle assembly. Refer to STEERING KNUCKLE REPLACEMENT .
  4. Install the rear steering gear assembly. Refer to STEERING GEAR ACTUATOR AND COVER REPLACEMENT .
  5. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  .
  6. Lower the vehicle.
Fig 2: Installing Lock Clip To Axle Shaft End
G01480632Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals