LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement (Tilt) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR CAUTION .
  1. Disable the SIR system. Refer to ZONE 3 .
  2. Remove the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Upper Bearing Thrust Washer .
  3. Remove the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
  4. Slide the turn signal switch housing off of the steering column shaft assembly.
  5. Remove the tilt head housing and steering shaft as an assembly. Refer to Lower Bearing and Steering Column Jacket Replacement (Column Shift Lean Shaft)  or Lower Bearing and Steering Column Jacket Replacement (Floor Shift Lean Shaft)  or Lower Bearing and Steering Column Jacket Replacement (Column Shift Standard)  or Lower Bearing and Steering Column Jacket Replacement (Floor Shift Standard) .
  6. Remove the tilt head from the steering shaft.
    Fig 1: Removing Tilt Head From Steering Shaft
    G01479795Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals