LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Steering Wheel And Steering Column) >> Repair Instructions >> Lower Bearing and Steering Column Jacket Replacement (Column Shift Standard) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 TORX® head screws (1).

    Tighten 

    Tighten the screws to 17 N.m (13 lb ft).

    Fig 1: Install Steering Column Support Assembly To Steering Column Jacket Assembly With Screws
    G01479850Courtesy of GENERAL MOTORS CORP.
  2. Install the steering shaft assembly (1) into the steering column support assembly (2).
    Fig 2: Install Steering Shaft Assembly Into Steering Column Support Assembly
    G01479851Courtesy of GENERAL MOTORS CORP.
  3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
  4. Install the linear shift assembly. Refer to Linear Shift Assembly Replacement .
  5. Install the turn signal and multifunction switch assembly. Refer to Multifunction, Turn Signal Switch Replacement .
  6. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement (Floor Shift)  or Ignition Lock Cylinder Case Replacement (Column Shift) .
  7. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  8. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  9. Enable the SIR system. Refer to ZONE 3 .
    Fig 3: Install Adapter & Bearing Assembly Onto Steering Column Jacket
    G01479852Courtesy of GENERAL MOTORS CORP.