LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1340 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (With Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to GRILLE REPLACEMENT (OLD STYLE)  or GRILLE REPLACEMENT (NEW STYLE GMC)  or GRILLE REPLACEMENT (NEW STYLE CHEVROLET)  in Exterior Trim.
    NOTE: Refer to POWER STEERING HOSE DISCONNECTED NOTICE .
  2. Place a drain pan under the vehicle.
  3. Siphon the fluid from the reservoir to prevent excess spillage.
  4. Remove the clamp retaining the power steering cooler inlet hose (3) to the power steering gear (2).
  5. Remove the clamp retaining power steering cooler outlet hose (5) to the power steering pump (1).
    6. Fig 1: Removing Inlet/Outlet Hose
    G01479540Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (2) retaining the power steering cooler from the radiator support.
  7. Remove the power steering cooler from the vehicle.
    Fig 2: Remove Radiator Support Bolts From Power Steering Cooler
    G01479541Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals