LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (Engine Controls Diagnostic (DTC P0068 To DTC P0174) -- 5.7L) >> Diagnosis >> DTC P0068 >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 5:  When the TAC module detects a condition within the TAC system, more than 1 TAC system related DTC may set. This is due to the many redundant tests that run continuously on this system. Locating and repairing 1 individual condition may correct more than 1 DTC. Disconnecting components during testing may set additional DTCs. Keep this in mind when reviewing the stored information, Capture info.
DTC P0068

Step Action Yes No
Schematic Reference:  Engine Controls Schematics 
Connector End View Reference:  Powertrain Control Module (PCM) Connector End Views  or  Engine Controls Connector End Views 
1 Did you perform the Diagnostic System Check-Engine Controls? Go to Step 2  Go to Diagnostic System Check - Engine Controls
2 Is DTC P0101, P0102, P0103, P0107, P0108, P0112, P0113, P1111, or P1112 set? Go to Diagnostic Trouble Code (DTC) List Go to Step 3 
3
CAUTION: Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.
IMPORTANT: If any of the conditions listed below exist, replace the throttle body assembly. Refer to Throttle Body Assembly Replacement .
Inspect the throttle body for the following conditions:
  • A loose or damaged throttle position (TP) sensor
  • A loose or damaged throttle blade
  • A cracked or bent throttle shaft
  • Drive mechanism damage
Did you find and correct the condition?		 Go to Step 4  Go to Diagnostic Aids
4
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 5 
5  Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List System OK
scientia non olet · About LEMON Manuals