Valve Rocker Arm Cover Installation - Right

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Fill Cap & Tube

Courtesy of GENERAL MOTORS CORP.

IMPORTANT:

All gasket surfaces should be free of oil or other foreign material during assembly.
DO NOT use the valve rocker arm cover gasket again.
The valve rocker arm cover bolt grommets may be used again.
If the oil fill tube has been removed from the valve rocker arm cover, install a NEW oil fill tube during assembly.

Lubricate the O-ring seal of the NEW oil fill tube with clean engine oil.
Insert the NEW oil fill tube into the rocker arm cover and rotate the tube clockwise until locked in the proper position.
Install the oil fill cap into the tube and rotate clockwise until locked in the proper position.

Fig 2: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Install a NEW gasket (504) into the valve rocker arm cover.

Fig 3: View Of Valve Rocker Arm Cover & Bolts (Right)

Courtesy of GENERAL MOTORS CORP.

Install the valve rocker arm cover onto the cylinder head.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the cover bolts with grommets.
Tighten: Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 4: View Of Ignition Coils

Courtesy of GENERAL MOTORS CORP.

Install the ignition coils, wire harness, and bolts onto the mounting bracket.
Tighten: Tighten the ignition coil bolts to 12 N.m (106 lb in).

Fig 5: Ignition Coil Bracket Bolts & Rocker Cover

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the bracket bolts.
Install the ignition coils and bracket assembly and bolts to the rocker cover.
Tighten: Tighten the ignition coil bracket bolts to 12 N.m (106 lb in).
Install the crankcase ventilation hoses to the cover.