LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Engine Controls - Removal, Overhaul & Installation - Except Diesel) >> Emission Systems & Sub-Systems >> EVAP Canister Purge Solenoid >> Removal (4.8L, 5.3L & 6.0L)

Removal (4.8L, 5.3L & 6.0L)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen retaining bolt on intake manifold sight shield at top of engine. See Figure. Remove intake manifold sight shield from top of engine. Disconnect EVAP canister purge solenoid harness connector. EVAP canister purge solenoid is located near top right front of engine. See Figure.
  2. Push retaining tab inward while pulling up on EVAP canister purge solenoid pipe connection to disconnect EVAP canister purge solenoid pipe from EVAP canister purge solenoid. Remove EVAP canister purge solenoid retaining bolt. Remove EVAP canister purge solenoid and isolator from intake manifold.
scientia non olet · About LEMON Manuals