No Reverse or Slips in Reverse
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
No Reverse or Slips in Reverse
| Checks |
Causes |
| Input Housing Assembly (602) |
- 3-4 Apply ring stuck in applied position
- Forward clutch not releasing
- Turbine shaft seals missing, cut or damaged
|
| Manual Valve Link (89) |
Disconnected |
| Valve Body Assembly (60) |
- 2-3 Shift valve stuck
- Manual linkage not adjusted
- Spacer plate and gaskets incorrect, mispositioned or damaged
- Lo overrun valve stuck
- Orificed cup plug restricted, missing or damaged
|
| Reverse Input Clutch Assembly (605-614) |
- Clutch plate worn
- Reverse input housing and drum assembly cracked at weld
- Clutch plate retaining ring out of groove
- Return spring assembly retaining ring out of groove
- Seals cut or damaged
- Restricted apply passage
- Porosity in piston
- Belleville plate installed incorrectly
- Excessive clutch plate travel
- Oversized housing
|
| Lo and Reverse Clutch (694-696) |
- Clutch plates worn
- Porosity in piston
- Seals damaged
- Return spring assembly retaining ring mispositioned
- Restricted apply passage
|
| Reaction Sun Shell (670) |
Broken spline on reaction sun shell/replace shell |