Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096): Clean-Up
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.
- Turn the main power switch to the OFF position.
- Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
- Disconnect the air supply hose from J 45096 .
- Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.
IMPORTANT:
A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.