LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Rear Drive Axle) >> Diagnostic Information and Procedures >> Constant Noise

Constant Noise

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Constant Noise

Cause Correction
IMPORTANT: Inspect for the proper gear oil levels prior to performing system diagnosis. Refer to Lubricant Level Inspection - Rear Drive Axle .
Low gear oil levels Faulty oil seals or other type leaks may contribute to lower than required fluid levels. Refer to Rear Axle Lubricant Leak Diagnosis .
Fill to the proper level with the correct gear oil and friction modifier additive. Refer to Sealers, Adhesives, and Lubricants  and Lubricant Change .
Worn, loose, or damaged axle mount and/or bracket Repair or replace the axle mount and/or bracket as required.
Bearing noise within the differential assembly A grinding or roar type noise will increase or decrease relative to the vehicle speed.
  1. Inspect for the proper fluid level. Fill as required.
  2. If the noise continues, repair or replace the unit as required.
Gear set whine noise within the differential assembly A whine type noise will increase or decrease relative to the vehicle speed, approximately 31-37 km/h (50-60 mph). Typical causes of a gear set whine type noise may include incorrect backlash and/or pinion depth adjustment or worn or scored gear set teeth.
  1. Inspect for the proper fluid level. Fill as required.
  2. Repair or replace the unit as required.
scientia non olet · About LEMON Manuals