Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Manifold & Nuts

Courtesy of GENERAL MOTORS CORP.

Install a NEW exhaust seal.
Raise the front of the catalytic converter.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the left and right exhaust manifold nuts.
Tighten: Tighten the exhaust manifold nuts to 20 N.m (15 lb ft).

Fig 2: Exhaust Pipe Hanger Lower & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the exhaust pipe hanger lower bolts.
Tighten: Tighten the exhaust pipe hanger bolts to 50 N.m (37 lb ft).

Fig 3: Exhaust Pipe Brace Lower & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the exhaust pipe brace lower bolts.
Tighten: Tighten the exhaust pipe brace bolts to 50 N.m (37 lb ft).
Remove the adjustable jack stand.
Lower the vehicle.