Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Outer Tie Rod End, Rear Suspension Adjustment Link & Jam Nut

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod end (3) to the rear suspension adjustment link (1).
Install the outer tie rod end into the suspension knuckle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the outer tie rod end nut (2).
Tighten:
- Tighten the outer tie rod end nut (2) to 20 N.m (15 lb ft) to seat the outer tie rod stud.
- Turn the nut an additional 160 degrees.
- Check the outer tie rod end nut for a minimum torque of 45 N.m (33 lb ft).
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
Adjust the rear wheel toe as necessary and tighten the rear suspension adjustment link lock nut. Refer to Rear Toe Adjustment in Wheel Alignment.