Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Disconnect the rear shock absorber electronic suspension control electrical (ESC) connector, if equipped.
- Remove the lower mounting bolt retaining the shock absorber to the lower control arm.
- Remove the shock upper mounting bolts.
- Remove the tie rod from the control arm. Refer to Rack and Pinion Outer Tie Rod End Replacement .
- Remove the shock absorber from the lower control arm and shock tower.
- Remove the upper insulator retainer and insulator from the shock absorber.